An essential accessory for every water softener, this salt alarm system is assembled outside the brine well and is powered by a 9V battery (not included) with a lifespan of over 4 years. Installation and operation - Assemble the appropriate clamps to the detector based on the outer diameter of the brine well (the package includes two 2" clamps and two 4" clamps). - Secure the detector to the outside of the brine well and adjust it to the correct height (as close as possible to the bottom grid). - Conn

Replacement parts chlo active Articles to assemble: J173-CPR16IS JG replacement O-ring OD tube 1/2" (x3pcs.) + S001-4200 Straight adaptor OD Tube - M. thread 3/8" x 3/8" (x2pcs.)

Dimension (ODxH): 99x63 mm.

The diameter measures 27mm. it is the most used and present in most water softeners.

Resin filling funnel O.D. 405mm. Suitable for: - 15000448 2" Screen bottom distributor pipe 50mm. for vessels from 18" to 24" upper thread 4" - 15000449 PVC Bottom screen basket tube OD50mm. (2") x 1800mm.

The brine valve have to be chosen based on the height of the pressure vessel installed in the water softener. In any case, the valves are suitable by adjusting the height to the pressure vessel used. Just follow the instructions below: 15000439-01: Brine valve suitable for all the pressure vessels with height 17" 15000439-02: Brine valve suitable for all the pressure vessels with height 35" 15000439-03: Brine valve suitable for all the pressure vessels with height 44"

Thanks to the small grid on the float valve bottom, any infiltration of undissolved salt is reduced.

15000430-01 For pressure vessels up to 48" tall 15000430-02 For pressure vessels up to 65" ta

15000430-01 For pressure vessels up to 48" tall 15000430-02 For pressure vessels up to 65" ta