Air ozone generators 3,5 - 5 - 3,5/7 - 10 Gr./H.

Air ozone generators 3,5 - 5 - 3,5/7 - 10 Gr./H.

Effectively removes smoke, pollen, dust, dust mites, molds, bacteria and viruses.

1. Sterilization: destroys a variety of bacteria and viruses efficiently.
2. Deodorization: completely removes mold, cigarette smoke.
3. Oxygen increasing: improves oxygen level for air.
4. Health: purify the air and promotes human metabolism.
5. Applicable areas: rooms, basements, vehicles and boats, hotels, smoking areas, garages, restaurants.

Features
1. Compact and portable size.
2. Low energy consumption, minimal maintenance.
3. Quiet operation.
4. No chemicals and no residual contamination.

Specification
Voltage: 120V/60HZ. , 220V-240V. / 50-60H.
Power: 100W.
Ozone output: 10Gr./H.
Timer: 2 hours timer + HOLD function.
HOLD function: Unit will work continuously.
Air flow: Max 100 CFM (2.8M3/Min).
Noise: 35DB.
Air supply: Air source.
Cooling-down method: Air cooling.
Applicable area: 1000 square meters.
Dimension: 230x180x170mm.

Operation
1. Plug the unit.
2. Turn the timer and select the time you need the unit to work, when you set the timer less than 20 minutes, you should turn it past 20 minutes, then turn it back to the minutes you want.
3. The unit start working and the indicator light is on.
4. The unit will be off automatically when it runs out its time and indicator light will be off.

Ceramic ozone plate
Service life: 8000 hours lifetime.
Dimension: 88x108x1 mm.

Steps to replace the ozone plate
1. Unplug the unit;
2. Lift plate holder top upward a little until it does not clutch the plate;
3. Push the holder top backward a little until you can take out the plate;
4. Take out the old plate slowly and gently;
5. Install the new plate also slowly and and gently, and clutch the plate again with the plate holder top.

Maintenance
When the unit produces less and less ozone or no longer produces any ozone, the old ozone plate needs to be replaced. Normally, the ozone plate needs to be replaced after working for 8000 hours.