Profine Pfas large replacement water filter 11.000lt. - 2lt./min 0,5 micron (6)

Profine Pfas large replacement water filter 11.000lt. - 2lt./min 0,5 micron (6)

Profine® Pfas designed to removes unwanted odors, flavors and Perfluoroalkyls (PFAS). Pfas selective resin, final filtration stage at 0.5 µm with Carbon Block technology added with silver ions for bacteriostatic action. To be used with Pfas concentrations up to 500 ng/l. If the cartridge is used in food processing equipment, the whole system must comply with the EU regulation 178/2002.

* Ideal for hotels, restaurants facilities, Ho.Re.Ca., Coffee Machines and multiple applications of Profine filters.
* Improves taste of beverages, sparkling water and post-mix systems.
* Protects your implants and removes completely scales due to limestone deposits.
* No electrical connection required.
* Vertical installation.
* The filter is easy to install and to replaces without using any special tool.

Features:
* Removes unwanted odors, flavors and Perfluoroalkyls (PFAS)

For use with:
04400202-07: Profine R replacement single filter head 2lt./min 10mm. quick fit.
04400202-11: Profine R replacement single filter head 2lt./min 8mm. quick fit.
04400202-15: Profine R replacement single filter head 2lt./min 3/8" quick fit.
04400202-19: Profine R replacement single filter head 2lt./min 1/4" quick fit.

• Technology: Pfas selective resin, final filtration stage at 0.5 µm with Profine® Carbon Block technology added with silver ions for bacteriostatic action
• Micron rating: 0,5 micron
• Service life: depending to the model, see table.
** Capacity varies according to:
* Inlet water quality
* Required flow rate
* Inlet water pressure
* Filter use (continuous or intermittent)

• Filter dimensions: HxD (mm.) MEDIUM 384x87,4(mm.) - 15,11”x3,44"(In.)
• Filter dimensions: HxD (mm.) LARGE 529x87,4(mm.) - 20,82”x3,44"(In.)
(Leave a vertical space of about 7 cm under filter to allow replacement).
• Activation: it is advisable to run water through filter at maximum pressure and full flow rate, for at least 5 minutes to allow air purging and flushing of cartridge.
• Filters change: When capacity is reached, or when flow comes too slow (precipitates under 0.7bar/10psi), every 6 months but at least annually.

Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before and after the system. Systems certified for the contaminants reduction may be used with disinfected water that may contain filterable pollutants. All systems must be maintained according to producer instructions.
Note: The contaminants or other substances removed or reduced by this drinking water system are not necessarily in your water.