Everpure JT Flushing & Sanitizing Replacement cartridge 2-size (1)

Everpure JT Flushing & Sanitizing Replacement cartridge 2-size (1)

Everpure JT

SANITIZATION
1* Take the central spout at the cartridge top and pull it out by pulling it outwards (see fig.). The spout with the entire tube will be removed from the cartridge.

2* Add about a Amuchina teaspoon or 90/120 ml. of common hydrogen peroxide (hydrogen peroxide) in the cartridge through the central hole.

3* Lubricate the central O-ring with a good lubricating silicone. Place the spout in the cartridge and insert it into system head.

4* After entering and hanging up the cartridge into its head, slowly open the valve of water supply line.
Run the water until there is an intense odor of the used sanitizing product. Then immediately turn off the water and wait at least half hour.

5* Make sure that the machine is not used during this period to allow adequate disinfection time. At the end, flush with plenty water at least 5 minutes to allow an adequate rinsing of the system and eliminate any air bubbles inside the cartridge.

6* Remove the sanitizing cartridge and insert a new Everpure cartridge.