RO1000 direct flow reverse osmosis 144ltr./h. without TDS regulator

RO1000 direct flow reverse osmosis 144ltr./h. without TDS regulator

The RO1000 is an innovative direct-flow reverse osmosis system designed for professional and HORECA applications where a continuous supply of high-quality water is required.

Thanks to its 1000 GPD membrane and advanced electronic management, it delivers reliable performance, minimal maintenance, and consistently high water quality, reducing up to 90% of salts, chlorine, calcium, sulfates, and total hardness.

Main features
- Direct production without storage tank: pure water always ready to use, with a flow rate of up to 2.4 L/min.
- Closed and compact system with encapsulated membranes and professional-grade components.
- High-efficiency 36 VDC electronic power supply for maximum safety and reliability.
- Low consumption and reduced wastewater: optimized permeate/reject ratio for maximum efficiency.
- Easy maintenance: direct front access to filters and components, quick replacement, and automatic counter reset.
- Full electronic control: acoustic and visual alerts, scheduled automatic flush cycles, low-temperature protection, and leak detection via dedicated anti-flood sensor.
- Smart DOT System - an intelligent external programmer with LED ring and touch controls for real-time monitoring of water quality, filter status, and membrane lifespan.

The LED ring changes color depending on the information being displayed:
- Blue: optimal conductivity
- Purple: filter nearly exhausted
- Red: maintenance required

Filtration
Filter 1: Polypropylene + CTO carbon block prefilter
Filter 2: 1000GPD encapsulated RO membrane

Features
Nominal production: 1000 GPD (2,4 L/min)
Operating pressure: 1-4 bar
Working temperature: 5-38 °C
Maximum inlet TDS: 1500 ppm
Voltage/rated frequency: 36VDC/230 VAC - 50/60 Hz
Dimensions: 456x401x155 mm

The reverse osmosis is not a device that makes water drinkable(non-drinkable water into drinkable water) and it work only if it's installed on water compliant with the law, municipal potable water or well water if previously made drinkable with adequate and effective systems, preventively studied and personalized for that kind of water.
Do not use the system where the water is microbiologically dangerous or of unknown quality without adequate disinfection before and after the system. All systems must be preserved according to the producer instructions.
The pollutant parts removed or reduced by this system are not necessarily in your water.
In case of potable inlet water of bad quality, it's possible to close all the outgoing mineral salts regulator (TDS) and to mount, as the last stage, a remineralizer filter that stabilizes the Ph.
1x Ionicore remineralizer PH adjustment coconut in line filter (GAC) 1/4" FPT 2"x10".

Filter replacement: when capacity is reached or when the flow rate becomes too slow, every 6 months, or at least once per year.
Membrane replacement: when TDS is no longer reduced or flow becomes too slow, at least every 24 months.