This site uses cookies to improve user experience ok, don't show again read privacy policy x
Languages
Products

LCD UV System Complete Set Ultrarays Purifier Germicidal Lamp

order
other filters

Pressurised accumulator tanks in steel painted blue 2,1 Gal.- 8 lt. (1)
Pressurised accumulator tanks in steel painted blue 2,1 Gal.- 8 lt. (1)
060061
Inner membrane: butyl * Inner covering: Polypropylene liner * Max. work pressure 7 kg/cm2. * Preloading pressure 0.5 kg/cm2. * Diameter: 202mm. * Height: 260mm. * Connection 1/4"
Pressurised accumulator tanks in steel painted white 2,2 Gal.- 8,3 lt. (1)
Pressurised accumulator tanks in steel painted white 2,2 Gal.- 8,3 lt. (1)
060047
Inner membrane: butyl Inner covering: Polypropylene liner Max. work pressure 7 kg/cm2. Preloading pressure 0.5 kg/cm2. Diameter: 230mm. Height: 360mm.
Pressurised accumulator tanks in steel and stainless steel 3,2 Gal.- 12,1 lt. (1)
Pressurised accumulator tanks in steel and stainless steel 3,2 Gal.- 12,1 lt. (1)
060046
Inner membrane: butyl Inner covering: Polypropylene liner Max. work pressure 7 kg/cm2. Preloading pressure 0.5 kg/cm2. Material: Steel Diameter: 275mm. Height: 340mm.
Pressurised accumulator tanks in steel plastic covering 5,5 Gal.- 21 lt. (1)
Pressurised accumulator tanks in steel plastic covering 5,5 Gal.- 21 lt. (1)
060048
Inner membrane: butyl Inner covering: Polypropylene liner Max. work pressure 7 kg/cm2. Preloading pressure 0.5 kg/cm2. Diameter: 280mm. Height: 410mm.
Pressurised accumulator tanks in steel painted blue 10,7 Gal.- 40,6 lt., 14,4 Gal. - 54,5 lt. (1)
Pressurised accumulator tanks in steel painted blue 10,7 Gal.- 40,6 lt., 14,4 Gal. - 54,5 lt. (1)
060050
060050-01 10,7 Gal.- 40,6 lt * Diameter: 390mm. * Height: 500mm. * Connection: 1"F. or open/close ball valve with compression fitting *060050-02 14,4 Gal. - 54,5 lt. * Diameter: 390mm. * Height: 580mm. * Connection: 3/4"F.
Accumulator tanks in steel 20 Gal.- 76 lt.
Accumulator tanks in steel 20 Gal.- 76 lt.
060051
Diameter: 400mm. Height: 730mm. Connection: 3/4"M.
Anti leak water (sensor + electronic board)
Anti leak water (sensor + electronic board)
060006
System to stop the water in-let. Sensor dipped in gold Electronic dedicated PCB Electrovalve Mod. 4030-ID00637 not included Voltage: 24V or 36V
Leaking sensor
Leaking sensor
060053
Set: electronic card + box + aquastop sensor
IEC tripolar built-in plug switch without fuse
IEC tripolar built-in plug switch without fuse
060068
Panel hole size (LxH): 47x28mm.
IEC power supply cable - schuko EU plug
IEC power supply cable - schuko EU plug
060070
Cable: 2mt. (3x0,75mm.)
RT-770 In-Line TDS Tester
RT-770 In-Line TDS Tester
060014
The RT-770 is an in-line and low cost testing device to monitor the quality of pure water which is generated by Reverse Osmosis water filters. It measures the conductivity of water and convert it to be TDS reading. The measured TDS reading is compared to the pre-setting TDS value. The RT-770 turns on RED light if the measured TDS reading is over the pre-setting TDS value. If it’s under the pre-setting TDS value, the RT-770 turns on Green light. Alert options available: 40ppm - 80ppm - 100ppm - 150ppm.
RT-790, In-Line Programmable Automatic TDS Tester
RT-790, In-Line Programmable Automatic TDS Tester
060015
The RT-790 is an in-line and low cost testing device to monitor the quality of pure water which is generated by reverse osmosis water filters. It measures the conductivity of water and convert it to be TDS reading. The measured TDS reading is compared to the pre-setting TDS value. The RT-790 turns on RED light if the measured TDS reading is over the pre-setting TDS value. If it’s under the pre-setting TDS value, the RT-790 turns on Green light. Feature : * Automatic testing or manual testing * Internal
Quick Check TDS/Conductivity Monitor
Quick Check TDS/Conductivity Monitor
060016
Press the "Push-to-Check" button for an instant water quality check! FEATURES * With the push of a button, the unit displays a green or red light, indicating good water quality or service required, respectively. * Tests for TDS or conductivity levels. * Eight programmable set points (by dip switch). * Bright LED lights. * Simple to use. * Factory Calibrated to 100 ppm NaCl. Re-calibration is unncessary. * Comes equipped with Mur-lok® Quick-Connect T-fitting (1/4 inch standard, also available in 3
Quick Check TDS LCD Monitor
Quick Check TDS LCD Monitor
060017
Ideal for any water filtration system, including reverse osmosis systems, coolers and much more. FEATURES * Displays TDS level of a single water line. * Highly efficient and accurate due to its advanced microprocessor technology. * Auto-Off function conserves battery power. The unit shuts off automatically after 10 minutes of non-use. * Wide Range 0-9990 ppm (From 0 - 999 ppm the resolution is 1 ppm. From 1000 to 9990 ppm, the resolution is 10 ppm, indicated by a blinking 'x10' image.) * Factory Cal
DM-1 In-Line Dual TDS Monitor
DM-1 In-Line Dual TDS Monitor
060018
Measure the tap water coming in vs. the purified water going out of your water filtration system at any time. FEATURES * Displays TDS levels of the feed water and product water with in & out electrode probes. * Highly efficient and accurate due to its advanced microprocessor technology. * Auto-Off function conserves battery power. The unit shuts off automatically after 10 minutes of non-use. * Dual Range 0-9990 ppm (From 0 - 999 ppm the resolution is 1 ppm. From 1000 to 9990 ppm, the resolution is 10
Dual TDS Sensor Probes for the DM-1
Dual TDS Sensor Probes for the DM-1
060019
* Stainless steel sensors * Probe: 1/4" * Cable: 24.5" * Connector: 8-pin * Thermometer pins: Yes * Each sensor of the pair has a blue or red wrap and labeled "IN" or "OUT" * Pressure Rating: 16bar @ +23°C
DM-2 Commercial/residential in-Line Dual TDS Monitor
DM-2 Commercial/residential in-Line Dual TDS Monitor
060020
Install on industrial systems such as car washes, window washing, manufacturing, and food processing. FEATURES * Highly efficient and accurate due to its advanced microprocessor technology. * Displays TDS levels of the Feed Water and Product Water with in & out electrode probes. * Auto-Off function conserves battery power. The unit shuts off automatically after 20 seconds. * Dual Range - Measures from 0-999 ppm, with a resolution of 1 ppm. From 1000 to 9990 ppm, the resolution is in 10 ppm increments
Dual TDS Sensor Probes for the DM-2
Dual TDS Sensor Probes for the DM-2
060021
* Stainless steel sensors * Probe: 1/4" * Cable: 45" (114,3 cm.) * Connector: dual 4+4-pin * Thermometer pins: Yes * Each sensor of the pair has a blue or red wrap and labeled "IN" or "OUT" * Pressure Rating: 16bar @ +23°C
PM1 OEM In-Line TDS purity monitor
PM1 OEM In-Line TDS purity monitor
060054
An ideal monitor/alert for water coolers and other enclosed water purification systems. Alerts a user when the filtration system requires service. FEATURES * OEM single line internal TDS monitor that is ideal for enclosed water purification systems. * Includes a light and optional alarm that alerts the user service is required when the TDS level reaches the pre-programmed set-point. * User-defined set points (any even number between 2 and 200). SPECIFICATIONS * Range: 0-200 ppm (mg/L) * Accuracy: +/
Electrolysis system for reverse osmosis test
Electrolysis system for reverse osmosis test
060058
The produced electrolysis process, as well as its viewing, increases intensity and reaction rate depending on the quantity of dissolved salts, among other factors. Water increases its electricity proportionally to the quantity of dissolved salts it contains. Contents of the briefcase: * Electrolysis precipitator * 2 aluminium electrodes * 2 iron electrodes * Transformer *
PM-2 external In-Line TDS Purity Monitor 220V.,110V.
PM-2 external In-Line TDS Purity Monitor 220V.,110V.
060065
An ideal monitor/alert for water coolers and other enclosed water purification systems. Alerts a user when the filtration system requires service. FEATURES * External single line internal TDS monitor that is ideal for most water purification systems. * Includes a light and optional alarm that alerts the user service is required when the TDS level reaches the pre-programmed set-point. * User-defined set points (any even number between 2 and 200). SPECIFICATIONS * Range: 0-200 ppm (mg/L) * Accuracy: +
DM-2EC Commercial/residential in-Line Dual Conductivity Monitor (5)
DM-2EC Commercial/residential in-Line Dual Conductivity Monitor (5)
060067
Inline ELECTRICAL CONDUCTIVITY monitor that can be installed on industrial water filtration systems such as car washes, window washing, manufacturing, and food processing. FEATURES * Highly efficient and accurate due to its advanced microprocessor technology. * Displays EC levels of the Feed Water and Product Water with in & out electrode probes. * Auto-Off function conserves battery power. The unit shuts off automatically after 3 minutes. * Dual Range - Measures from 0-999 µS, with a resolution of
92 products found - 4 pages
|<<<3
4
>> >|

www.sinergroup.it Everpure Filters