Digiflow 6000R-L Flow meters LCD volume in liters (50)

Digiflow 6000R-L Flow meters LCD volume in liters (50)

The flow meter is able to totalize 99,999 liters and monitor up to 5 different filters simultaneously.
The LCD display flashes and sounds an alarm when the filter life limit will be reached.

Features:
Min. flow rate: 1.51 L/min (0.40 Gpm)
Max. flow rate: 11.36 L/min (3.00 Gpm)
Min. pressure: 0.57 Bar (8 psi)
Max. pressure: 7.86 Bar (110 psi)
Inlet - Outlet: 3/8" M NPT
Power supply: 2x AAA batteries

DIGIFLOW 6000R user instructions
Battery Installation
Slide to open the battery compartment cover and insert 2 AAA batteries. Close the cover.

Setting the capacity for each filter
Press and hold DISPLAY for 4-5 seconds, then press RESET and release both buttons. The DigiFlow 6000R will enter into the filter capacity registration procedure. The first number on the right will flash "1" twice (indicating the filter number) and its capacity.

Press DISPLAY to select the capacity for the filter n°1. The sequence is 100-200-300…, 9800-19900-OFF-0-100 (in gallons) or 500-1000…, 99500-OFF-500 (in liters).

Press and hold DISPLAY to speed up the selection sequence. After selecting the correct capacity, press RESET to save the setting. The procedure will move to filter n°2 configuration. The second second number on the right will flash "2" twice and you can repeat the same procedure as previously performed to configure up to 5 filters. The setup procedure will end and return to the original state if there is no input for 10 seconds.

Operations
The DigiFlow 6000R will turn on automatically when water flows through it. It will automatically turn off after 10 seconds with no water flow.

Press DISPLAY to view the volume of water detected up to that point.
Press DISPLAY again to view the remaining capacity of each filter. On the DigiFlow 6000R, the filter number will flash twice and then indicate the remaining capacity for a total of 5 filters.

End of capacity alarm
When each filter reaches a capacity of 0, the Digiflow will produce an audible alarm to alert the user to change the filters. Press RESET to turn off the alarm and reset the filter capacity.

Low battery alarm
When the battery power is lower than the normal operating level, a buzzer will emit two beeps to warn of the need to change the batteries. All previously entered settings will be retained in memory in case the battery is completely discharged or removed.

Reset
Press and hold RESET for 8 seconds to reset the flow meter.