Automatic water softener electronic BNT1650F valve 1", regeneration metered-time.
Low consumption of water and salt per regeneration.

Programming is simple and fast
- Insertion the time.
- Insertion day of week.
- Time of regeneration.
- Number of days between regenerations.
- Hardness input.

Hardness regulator output
Is required output minimum hardness of around 15°F, but the most commonly used setting is not less than 5°F.
Loosening action will reduce mixing with raw water output. To mix a specific output hardness value, adjust screw and test water. Repeat the procedure until you reach the desired hardness value. To check input/output hardness from the device, we recommend to buy cod. 13000001 Titrant kit total hardness (1°F) 15cc single reagent.

To buy with every softener:
1x 02001014-02 3-pieces standard housing 10" clear IN-OUT 1" with wrench & wall mounting bracket.
2x 04001006-05 Ionicore wound polypropylene cartridge 9-3/4" - 50 micron (50)
1x Kit 13000001 Titrant total hardness (1°F) 15cc single reagent.)
* Water softeners are supplied without salt, we recommend to use pads salt.

The device is assembled and programmed with a input hardness of 40°F, hardness of 0°F output and a safety regeneration every 7 days.

Indicated for the automatic residential softener systems, this valve is controlled with a simple and user-friendly electronic display on a LCD screen. The display shows key informations such as the regeneration mode, the remaining volume (meter mode) and the regeneration remaining days (timer mode).

2 Valve functions
- Softener.
- Filter.

4 Regeneration modes
- Calendar clock.
- Meter immediate.
- Meter delayed.
- Meter override.

The water hardness can be regulated using the simple mixing valve on the body of the valve in order to get the desired outlet hardness.

All the keys will be blocked after 3 minutes during the stand-by status, press and hold "MENU" key for 3 seconds to unlock.

The by-pass is included with the valve, ready to be installed.

Benefits and advantages
Reduction of water hardness, which is cause of scale.
Energy saving.
The device prevents formation of deposits in pipes and hydraulic lines.
Greater sense of wellness during shower, skin soft and clean.
Increased duration of appliances and boilers.
Cost saving.
Reduction in use of soaps, fabric softeners and chemicals.
Reduced maintenance costs.
Fully automatic operation.
It should just worry about adding salt in water softener.

Increased sodium (for drinking water)
Most of the sodium consumed is taken with foods, especially ones obtained with industrial processing. Salt is a great preservative and therefore is used as an additive for processed products. The assumption of sodium with the water we drink is relatively low compared to that which is taken with food. All softeners to produce softened water through ion exchange resins in, produce softened water output sodium ions. The recommended sodium limit for water intended for human consumption is 200ppm liter. Depending on sodium concentration and water hardness, it is possible that presents an higher sodium concentration than recommended. Where this is the case or if you need to follow a low salt content, it is advisable to install a domestic reverse osmosis for drinking water.

Features:
- Hydrostatic test pressure: 350psi (24,14bar)
- Working pressure: 20-125 psi (1,38-8,62 bar)
- Working temperature 1-39°C
- Electrical Adapter Input: AC 110/240V. - 50/60Hz
- Electrical Adapter Output: AC 12V.
- Pressure Tank Thread: 2,5" npsm
- Inlet/Outlet Connector: 1", 3/4", 1/2" (ppr, ppo, brass)