Dual-action filtration system consisting of a column of anionic resins loaded with iron hydroxide, characterized by high selectivity for the removal of Arsenic III and V, and an internal mechanical filtration system with a carbon fiber disc for the reduction of suspended particles.

The ion exchange action performed by the resin ensures high effectiveness in the selective reduction of arsenic, bringing it back to concentrations within the legal limit.

The column of anionic resins loaded with iron hydroxide provides exceptional selectivity for the removal of Arsenic III and V, ensuring high effectiveness in reducing this contaminant.

The internal mechanical filtration action reduces suspended particles, contributing to the overall improvement of treated water quality.

ARSENIC filters are designed to act as an intermediate filtration stage in water treatment systems and can be used as a specific pre-treatment before other filters in the treatment line.

When used for water intended for human consumption, the use in combination with a REFINER ® filter is recommended.

Filters with Rapid System connection to be used with the appropriate filter head. The connection is compatible with filter heads of the main products available on the market. Flow rate may vary depending on inlet pressure.

* Selective reduction of arsenic level
* Effective in the removal of Arsenic III and V
* Ideal for POU filtration systems
* Ideal as pre-treatment in systems where water is intended for food or beverage processing
* Suspended particle reduction
* Improves taste
* Does not require electrical power
* Vertical and horizontal installation
* Easy installation and replacement
* Disposable filter cartridge

Features:

* Maximum arsenic reduction capacity
* Selective removal of Arsenic III and V
* Suspended particle reduction
* Technology: anti-arsenic ion exchange resins with internal mechanical filtration
* Minimal flow loss and maximum flow rate
* Internal mechanical filtration with carbon fiber disc

• Technology: anionic resins loaded with iron hydroxide, internal mechanical filtration
• Capacity 250: 5.000ltr.
• Capacity 350: 7.500ltr.
• Capacity 500: 12.000ltr.

** Resin nominal capacity is calculated with 50 ppb As V and may vary depending on:
* inlet water quality
* required flow rate
* inlet water pressure
* filter usage

• Flow rate 250: 5,83 ltr./min. (1,54 gpm)
• Flow rate 350: 6,67 ltr./min. (1,76 gpm)
• Flow rate 500: 7,50 ltr./min. (1,98 gpm)
• Temperature: 3-30°C (36-92°F)
• Pressure: 1-7 bar (15-100 psi), non shock
• Filter dimensions 250 HxD (mm): 268 x 79 mm
• Filter dimensions 350 HxD (mm): 385 x 79 mm
• Filter dimensions 500 HxD (mm): 535 x 79 mm
• Connection: Rapid System
• Installation: vertical and horizontal

• Activation: it is recommended to flush water through the filter at maximum pressure and flow rate for 5 minutes in order to allow the air inside the cartridge to be purged.

• Cartridge replacement: it is recommended to replace the unit annually and/or every 6 months when its capacity is exhausted or when a significant increase of ARSENIC in outlet water is detected.

Do not use with microbiologically unsafe or unknown quality water without adequate disinfection before or after the system. Use only with potable water. All systems must be maintained according to the manufacturer’s instructions.
Note: The contaminants removed or reduced by this system may not necessarily be present in your water.