Profine ARSENIC small antimicrobial replacement filter 10.000lt. - 1lt./min 0,5 micron (6)

Profine ARSENIC small antimicrobial replacement filter 10.000lt. - 1lt./min 0,5 micron (6)

Reduces concentration of arsenic in drinking water. Carbon block filtration with antimicrobial 0.5 micron and selective resin for arsenic, mixed with active carbon.
Profine® ARSENIC remove odor and taste. The disposable filter is made of with extruded carbon block technology and silver for a bacteriostatic action.

Removes taste and odor, chlorine, dirt, rust, suspended material not visible to the naked eye, mold and algae. Reduction arsenic (type "III" trivalent and "V" pentavalent) if higher than to the limits of potability.
Composite structure filter suitable for the treatment of drinking water. Resin compliant to the NSF 61 and WRAS standards, the remaining components in contact with water compliant to DM 174/2004.
For drinking water with arsenic concentration 10 µg/l.

* Ideal for drinking and cooking in maximum safety.
* Improve taste of beverages, sparkling water and post-mix systems.
* Protect from clogging, corrosion and wear.
* No electrical connection required.
* Vertical installation with filter head "R" type.
* The filter is easy to install and replace without use of special tools.

Profine ARSENIC range with antimicrobial protection inhibits any potential bacterial growth.

Features:
* Chlorine reduction
* Arsenic reduction
* Bacteriostatic
* Reduction of particulate in suspension

• Technology: Multistage, Carbon Block (CB)
• Micron rating: 0,5 micron
• Service life: depending to the model, see table.
** Capacity varies according to:
* Inlet water quality
* Required flow rate
* Inlet water pressure
* Filter use (continuous or intermittent)

• Filter dimensions: HxD (mm.) SMALL 269x87,4(mm.) - 10,59”x3,44"(In.)
• Filter dimensions: HxD (mm.) MEDIUM 384x87,4(mm.) - 15,11”x3,44"(In.)
• Filter dimensions: HxD (mm.) LARGE 529x87,4(mm.) - 20,82”x3,44"(In.)
(Leave a vertical space of about 7 cm under filter to allow replacement).
• Activation: it is advisable to run water through filter at maximum pressure and full flow rate, for at least 5 minutes to allow air purging and flushing of cartridge.
• Filters change: When capacity is reached, or when flow comes too slow (precipitates under 0.7bar/10psi), every 6 months but at least annually.

Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before and after the system. Systems certified for the contaminants reduction may be used with disinfected water that may contain filterable pollutants. All systems must be maintained according to producer instructions.
Note: The contaminants or other substances removed or reduced by this drinking water system are not necessarily in your water.