Digiflow 8300T-44 flow meter LCD volume in liters (50)

Digiflow 8300T-44 flow meter LCD volume in liters (50)

Digital flow meter with external turbine, designed to monitor the water volume in liters or gallons, with filter capacity monitoring function.

Connection:
Inlet – outlet: 1/2” BSP male

Features:
- Flow rate: 1,5 - 25,0 L/min (0,40 - 6,60 Gpm)
- Temperature: 0 - 80°C (32 - 170°F)
- Max. working pressure: 8 bar (112 psi)
- Burst pressure: 29 bar (400 psi)
- Filter capacity monitoring (from 1 to 99.999 liters)
- End of filter capacity alert, with zero counting and minus counting
- Audible alert for end of capacity
- Audible low battery alert
- Battery operated (2 AA alkaline batteries)
- Automatic data saving in absence of power
- Measurement accuracy: ±10%
- Repeatability: 1%

Application:
- Under-sink water treatment system
- Commercial water treatment systems
- Water dispenser
- Water softeners

Construction features:
- Installation: vertical or horizontal
- Sensor body: Nylon reinforced with 30% glass fiber
- Turbine: Plastic magnet
- Turbine shaft: Stainless steel (ceramic option)
- O-ring: EPDM
- Control unit housing: ABS
- Cable length: 1,5 m


OPERATION GUIDE

INSTALL BATTERIES
Slide off the cover case of the battery room, and put into two AA alkaline batteries. Then slide the cover case back. The power of two AA alkaline batteries could last for two years.

CONNECTING FITTING
The thread specification of the DigiFlow 8300T-44 connectors is 1/2” BSP male.

PROGRAMMING MONITORING CAPACITY
Press “PROG” button, the “ProG” blinks on the LCD. Then press “RESET” to choose the right value to save from the right digit. Once the value is chosen, press “PROG” button to save the value and goes to the next digit. Repeat the above procedure to program the values for five digits from right to left. The maximum monitoring capacity for the DigiFlow 8300T-44 is 99.999 liters.
* If there is no input for one minute during the programming procedure, the programming procedure will be terminated and goes back to the original status.

OPERATING
The DigiFlow 8300T-44 automatically turns on and displays the remaining capacity when there is water flowing through the sensor. And it automatically turns off in 10 seconds when there is no water flowing.

END OF CAPACITY ALERT
The DigiFlow 8300T-44 generates an audible alert and the digits on the LCD blinks when its remaining capacity reaches zero or minus.

RESETTING
Press the “RESET” button for three seconds, the “rESEt” on the LCD blinks twice, and the remaining capacity is reset to the original programming value.

LOW BATTERY POWER ALERT
When the battery power is low, the DigiFlow 8300T-44 generates an audible alert and the empty battery symbol on the right-up corner of the LCD blinks. The alert status will be released when the batteries are replaced by new batteries. The data of the last status will be memorized and stored back.