Single tank water softener valve Clack WS1CI 1" electronic (Reg. Metered-time) 15lt. resin

Single tank water softener valve Clack WS1CI 1" electronic (Reg. Metered-time) 15lt. resin

Automatic water softener. Electronic WS1CI Clack valve 1 " (Reg. Metered-time).Low consumption of water and salt per regeneration Valve body made of Noryl plastic material, NSF listed. Programming is simple and fast, just enter the time, day of week, time of regeneration, typically 02.00 at night, number of days between regenerations and hardness input. Complete with plug adapter 12/230V - 50Hz European plug. Hardness regulator output. Is required output minimum hardness of around 15°F, but the most commonly used setting is not less than 5°F. Loosening action will reduce mixing with raw water output. To mix a specific output hardness value, adjust screw and test water. Repeat the procedure until you reach the desired hardness value. To check input/output hardness from the device, we recommend to buy cod. 13000001 Titrant kit total hardness (1°F) 15cc single reagent.

TO BUY WITH EVERY SOFTENER
1x 15010302 Clack WS1CI / WS1TC Valve bypass
1x 02001014-02 3-pieces standard housing 10" clear IN-OUT 1" with wrench & wall mounting bracket.
2x 04001006-05 Ionicore wound polypropylene cartridge 9-3/4" - 50 micron
1x Kit 13000001 Titrant total hardness (1°F) 15cc. single reagent
* Water softeners are supplied without salt, we recommend to use pads salt.

The device is supplied programmed with a input hardness of 40°F, hardness of 0°F output and a safety regeneration every 7 days.
A bypass valve system (if ordered) must be installed on all systems. The bypass valves isolate the device from the water system and allow the use of untreated water. Routine maintenance or service may also require that the system is put in bypass.

Features:
* Simple and intuitive programming
* Solid state microprocessor with settings from front panel.
* Large LCD display.
* 48 hours of internal power backup.
* Real day time in hours and minutes.
* Residual volume of softened water.
* Display of regeneration phases and cycle remaining time.
* Fast and easy configuration of regeneration capacity, time and day.
* The set program remains in memory and will not be lost in case of power outages.
* Electronic regenerations step-by-step.
* Regeneration manual, delayed or immediate.
* Lack salt alarm.

Specifications
* Min. pressure: 1.4 bar (1.4 kg/cm2)
* Max. pressure: 8.6 bar (8.6 kg/cm2)
* Min. temperature: 4 ° C
* Max. temperature: 43 ° C
* Water Input / Output 1" male thread
* Exhaust: hose connector with 2m. of tube
* Overflow: hose connection 3/8 "

Model Specifications 15000203-15 15lt. resin (for 3/4 people)
* Exchange capacity: 75ºHFxm3.
* Salt consumption for regeneration: 1,95 Kg./sale.
* Water consumption for regeneration: 105lt.
* Quantity of treated water for regeneration, 30°F-2,5m3, 35°F-2,14m3, 40°F-1,87m3, 45°F-1,66m3, 50°F-1,50m3, 60°F-1,25m3.
* Max. flow: 0,67m3/h