Omnipure CL10RO T/33 GAC in line filter 1/4" NPT 2"x10" - 5 micron (25)

Omnipure CL10RO T/33 GAC in line filter 1/4" NPT 2"x10" - 5 micron (25)

Reduction of odor, color, taste, chlorine, dirt, rust, suspended material not visible at naked eye, mold and algae.
Designed in order to be located inside of machinery.

* Improve taste of beverages.
* Protect from clogging, corrosion and wear.
* No electrical connection required.
* Installation horizontal or vertical.
* The rapid filter is easy to install and replace without use of special tools.

The IN LINE cartridges do not require a filter head or bayonet joints for their installation and may be placed in any position (horizontal or vertical).

Features:
* Chlorine reduction

• Technology: Granular activated carbon (GAC) acid washed
• Micron rating: 5 micron
• Service life: see table
** Capacity varies according to:
* Inlet water quality
* Required flow rate
* Inlet water pressure
* Filter use (continuous or intermittent)
• Filter dimensions HxD (mm.): 50,79x254(mm.) - 2”x10"(In.)
• Activation: it is advisable to run water through filter at maximum pressure and full flow rate, for at least 5 minutes to allow air purging and flushing of cartridge.
• Change cartridges: When capacity is reached, or when flow comes too slow (precipitates under 0,7bar/10psi), every 6 months.

Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used with disinfected water that may contain filterable cysts. All systems must be maintained according to producer instructions.
Note: The contaminants or other substances removed or reduced by this drinking water system are not necessarily in your water.